glock mag conversion and g43 and g48 cut guide for 92f mags
Source: Thingiverse by desertheatpharmacist
The glock mag conversion and g43 and g48 cut guide for 92f mags is a free printable 3D model from Thingiverse by desertheatpharmacist. Over 80% of the "wonder 9's" use the same design of mag architecture with just the mag catch in another location.Have a look at magazines from makers and you will see, browning. You can download the STL file from the original listing below and print it at home.
About this model
Over 80% of the "wonder 9's" use the same design of mag architecture with just the mag catch in another location.Have a look at magazines from makers and you will see, browning, hk, Springfield beretta ruger sig and others have all used this basic form factor in different pistols over the ages. And glock mags are pretty much the same steel liner as these other mags, then covered in a thin layer of plastic. I used 92f and m9 mags in my XD9 and my sd9ve by just cutting the catch hole in the right place. For glocks the slide stop engagement point is located much higher than the Beretta so you need to print a glock 17 follower, or glue in a small filler piece. With the adapter super-glued in the correct place they fit the g17, and of course any thing shorter, g19 etc. Conversely if you can use…
Frequently asked questions
- Is this 3D model free to download?
- Yes. glock mag conversion and g43 and g48 cut guide for 92f mags is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by desertheatpharmacist.
- Who made this model?
- Designed by desertheatpharmacist, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
