CR-10s Circular Fan Duct (for Stock Fan Mount)
Source: Thingiverse by Prohmann
The CR-10s Circular Fan Duct (for Stock Fan Mount) is a free printable 3D model from Thingiverse by Prohmann. After upgrading to the Micro Swiss nozzle, most fan ducts I found on this site were either too thick or required the stock metal fan case to be swapped against some less stable. You can download the STL file from the original listing below and print it at home.
About this model
After upgrading to the Micro Swiss nozzle, most fan ducts I found on this site were either too thick or required the stock metal fan case to be swapped against some less stable plastic one. I have designed this fan duct from scratch. On the Creality CR-10s it can replace the stock fan duct. It works fine with the shorter Micro Swiss nozzle, therefore it should also work with the stock nozzle. There are two files included. One has a straight air intake, the other one will guide the air in the intake over a slight slope. I have no clue wether the slope will increase the effectiveness in measurable ways, so it is for you to decide which one you prefer.
Frequently asked questions
- Is this 3D model free to download?
- Yes. CR-10s Circular Fan Duct (for Stock Fan Mount) is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Prohmann.
- Who made this model?
- Designed by Prohmann, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in CR-10s
/https://fbi.cults3d.com/uploaders/31215298/illustration-file/d0ff3b57-f22b-412a-89fd-a3ce631f1152/1.jpg)
