Is this 3D model free to download?

Yes, 24mm Two-position Push Button (Device, Start-Stop, Switch) Box Enclosure is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by KillaCycle, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

24mm Two-position Push Button (Device, Start-Stop, Switch) Box Enclosure 3D printable model by KillaCycle

24mm Two-position Push Button (Device, Start-Stop, Switch) Box Enclosure photo 1

24mm Two-position Push Button (Device, Start-Stop, Switch) Box Enclosure photo 2

24mm Two-position Push Button (Device, Start-Stop, Switch) Box Enclosure photo 3

24mm Two-position Push Button (Device, Start-Stop, Switch) Box Enclosure

Source: Thingiverse by KillaCycle

The 24mm Two-position Push Button (Device, Start-Stop, Switch) Box Enclosure is a free printable 3D model from Thingiverse by KillaCycle. This enclosure will hold two(2) industry standard 24mm devices, such as start-stop buttons, emergency stop button, 24mm switches, etc. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-11-04 License: CC-BY-SA · commercial OK Category: Gadgets & Electronics

Tags: 24mm, dual, enclosure, start switch, stop switch, switch

About this model

This enclosure will hold two(2) industry standard 24mm devices, such as start-stop buttons, emergency stop button, 24mm switches, etc. Top part has a small lip which nests inside the bottom part. Screws together using four(4) 25mm M4 screws. You _should_ tap the bottom holes, but you can simply have the screws thread themselves if you don't own a tap. :-) Drill holes in the bottom or side(s) as required for attachment and wiring.

Frequently asked questions

Is this 3D model free to download?: Yes. 24mm Two-position Push Button (Device, Start-Stop, Switch) Box Enclosure is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by KillaCycle.
Who made this model?: Designed by KillaCycle, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.