Filament Enclosure Tap (1.75mm)
Source: Thingiverse by dottom22
The Filament Enclosure Tap (1.75mm) is a free printable 3D model from Thingiverse by dottom22. This part was inspired by the many filament cleaners that use a hollow chamber filled with some pliable porous material. You can download the STL file from the original listing below and print it at home.
About this model
This part was inspired by the many filament cleaners that use a hollow chamber filled with some pliable porous material. However the intent of this was to allow the spool and spool holder remain in a moisture resistant container while in use by the printer. This is my second rendition so far and am still working out some of the kinks. *********************************************************************************************************** Instructions: Your container that holds the spool and spool holder must have a 22mm whole drilled out to fit the threaded portion through. Then an equal sized O-Ring or gasket between the NUT and inner side of the case. Tighten the Nut until the Tap is firmly in place. The inside of the Tap will allow any soft sponge or foam material and the filament to…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Filament Enclosure Tap (1.75mm) is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by dottom22.
- Who made this model?
- Designed by dottom22, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in box
/https://fbi.cults3d.com/uploaders/38046271/illustration-file/186751dc-d5e1-4c99-a720-c7ddb2faf59d/tmp2lfq18ih.png)
