Bowden X-Carriage Mount for E3D V6
Source: Thingiverse by JackWaterfall
The Bowden X-Carriage Mount for E3D V6 is a free printable 3D model from Thingiverse by JackWaterfall. ####Consider supporting me by sending me a tip on thingiverse or PayPal. You can download the STL file from the original listing below and print it at home.
About this model
####Consider supporting me by sending me a tip on thingiverse or PayPal. ####paypal.me/jackwaterfall ###Make sure to post a make if you print one! ###Updates 31/07/2017 - New sensor mounts, support for SN04-N sensor. Included cable clamp to clamp cables to the top of the mount for better cable management. Improved fan duct placement and design. 17/02/2017 - Added a BlTouch sensor variant. 13/01/2017 - Added an 18mm sensor variant. 08/01/2017 - First release. ###What Is It? If you are upgrading your Prusa i3 hotend to the E3D V6 or a V6 clone hot-end with the standard groove mount, you'll need some way of mounting it to your x-carriage. The mount attaches to the x-carriage using the same four hole mounting system that is used on the Prusa I3 rework 1.5 kit, so you will need to print off a c…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Bowden X-Carriage Mount for E3D V6 is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by JackWaterfall.
- Who made this model?
- Designed by JackWaterfall, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Bowden
