Extended18 Dart NERF Magazine
Source: Thingiverse by SCHEMENKE
The Extended18 Dart NERF Magazine is a free printable 3D model from Thingiverse by SCHEMENKE. Remix - NERF Magazine by iliis, (extended length to ~13, ~17 or ~20 darts) Extended length of iliis's magazine design to accommodate either ~13, ~17, or ~20 darts. You can download the STL file from the original listing below and print it at home.
About this model
Remix - NERF Magazine by iliis, (extended length to ~13, ~17 or ~20 darts) Extended length of iliis's magazine design to accommodate either ~13, ~17, or ~20 darts. The Base and Slider are exactly as iliis made them. however I have included a second, slightly smaller, version of the slider (SLIDERv2) that seems to slide better. This can be printed without supports, (upright) but will be a good height test for the printer. - The bottom section of the 13 dart magazine is ~200 mm tall, and the 17 dart magazine is just under 230mm tall - Be sure not to exceed the height of your printer! You will need to Glue or Weld the 20 dart model as it is printed in two pieces. I welded the two halves of the 20 dart print using some scrap PLA (of the same color) and an old Soldering iron. I have Tested the …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Extended18 Dart NERF Magazine is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by SCHEMENKE.
- Who made this model?
- Designed by SCHEMENKE, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Extended18
