Is this 3D model free to download?

Yes, Tent Pole Bungee End Caps is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Mholiv, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Tent Pole Bungee End Caps 3D printable model by Mholiv

Tent Pole Bungee End Caps

Source: Thingiverse by Mholiv

The Tent Pole Bungee End Caps is a free printable 3D model from Thingiverse by Mholiv. These replacement end caps were designed to fit common carbon-fiber and fiberglass tent poles. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-11-01 License: CC-BY-NC-SA · non-commercial Category: Outdoor & Garden

Tags: bungee, cap, openscad, replacement, tent, Tent Pole

About this model

These replacement end caps were designed to fit common carbon-fiber and fiberglass tent poles. They allow the internal bungee cord to be reattached after replacing a damaged pole segment. The cord passes through the opening in the cap and is secured at the end of the final pole section. Tent pole segments are held together by a bungee cord running through their center. Replacing a broken segment is relatively straightforward, but the original end cap may be difficult or impossible to reuse. These caps provide a new anchor point, allowing the repaired pole to stay together and fold normally. All you need to do is to feed the bungee cord through the opening, tie a knot in the end, and fit the cap over the pole. You can then glue (flexible glue recommended) the round endcap over the knot. For…

Frequently asked questions

Is this 3D model free to download?: Yes. Tent Pole Bungee End Caps is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Mholiv.
Who made this model?: Designed by Mholiv, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.