Power Strip Desk Mount
Source: Thingiverse by ragingcomputer
The Power Strip Desk Mount is a free printable 3D model from Thingiverse by ragingcomputer. Clamp for mounting a power strip to the edge of a desk at an angle. You can download the STL file from the original listing below and print it at home.
About this model
Clamp for mounting a power strip to the edge of a desk at an angle. I guesstimated a 40 degree angle from the desk would be easy to plug in while reaching across the desk. Desk is 1.5 in thick countertop. Clamps around the edge of the desk. Used adhesive backed rubber pads to stop the clamps from marring the desk or sliding around. No modification of the power strip necessary. Uses existing mounting holes. #4-40 x 1/2 machine screws hold the power strip on. Nuts are slid into the slot and screws put in from the front. Clamps to the desk using a #8-32 machine screw into a nut in a slot Designed around this power strip. Using these adhesive backed rubber pads.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Power Strip Desk Mount is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by ragingcomputer.
- Who made this model?
- Designed by ragingcomputer, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Power
