Anemometr v.4.0 - With a Speed Sensor + Rain resistant
Source: Thingiverse by flashgorshkov
The Anemometr v.4.0 - With a Speed Sensor + Rain resistant is a free printable 3D model from Thingiverse by flashgorshkov. 1. You can download the STL file from the original listing below and print it at home.
About this model
1. Rain resistant. 2. Place for a1120 Hallsensor. 3. Don't need model support. 4. The perimeter of the circle is 50 centimetres, thus, at a wind speed of 1 meter per second, the anemometer makes 2 full revolutions. 5. Need bearing 608ZZ. 6. Need 2 round neodymium magnet 2x2 mm. 7. Need a1120 Hallsensor. 8. The sensor should be bent by 90 degrees, as shown in the preview. 9. After installation, the sensor must be waterproof, for example using epoxy resin or analogues.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Anemometr v.4.0 - With a Speed Sensor + Rain resistant is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by flashgorshkov.
- Who made this model?
- Designed by flashgorshkov, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Anemometr
