Is this 3D model free to download?

Yes, Micro Flying Wing for V911/F949 receiver bricks is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by drcameron, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Micro Flying Wing for V911/F949 receiver bricks 3D printable model by drcameron

Micro Flying Wing for V911/F949 receiver bricks photo 1

Micro Flying Wing for V911/F949 receiver bricks photo 2

Micro Flying Wing for V911/F949 receiver bricks photo 3

Micro Flying Wing for V911/F949 receiver bricks photo 4

Micro Flying Wing for V911/F949 receiver bricks

Source: Thingiverse by drcameron

The Micro Flying Wing for V911/F949 receiver bricks is a free printable 3D model from Thingiverse by drcameron. I designed the wings using TinkerCAD. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

7,358 saves Source: Thingiverse Updated 2026-10-25 License: CC-BY-NC · non-commercial 27 makes Category: Vehicles & RC

Tags: airplane, f949, flying wing, plane, RC plane, v911, wltoys f949

About this model

I designed the wings using TinkerCAD. The purpose is to use them for a micro RC flying wing. Version 2: The assembled wing is 40cm (400mm). I was able to print each wing diagonally on my Monoprice Maker Select 3d v2.1 printer that has a 200mm build plate. I covered the wings with packing tape and used foam plates to cut out winglets that I drew freehand. The control horns were scaled down (75%) from these: The CG is just behind the box that holds the receiver brick. The receiver brick and motor are attached using hot glue. I've successfully flown it using the Flysky module and the T8SG tx. Update on flying: I got a new module for my tx so no more drop outs. Adjusted controls including rates at 60/80/100. First flight: Version 3 It also has a holder for a camera, has built in control horns,…

Frequently asked questions

Is this 3D model free to download?: Yes. Micro Flying Wing for V911/F949 receiver bricks is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by drcameron.
Who made this model?: Designed by drcameron, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.