Pulley (Block and tackle)
Source: Thingiverse by stewartmiller
The Pulley (Block and tackle) is a free printable 3D model from Thingiverse by stewartmiller. This is a block and tackle pulley system for use with 5mm paracord (I am sure other sizes could work too) It requires two M5 carriage bolts >35mm, two m5 nuts and two small. You can download the STL file from the original listing below and print it at home.
About this model
This is a block and tackle pulley system for use with 5mm paracord (I am sure other sizes could work too) It requires two M5 carriage bolts >35mm, two m5 nuts and two small washers to fit between the nut and the printed block. A large washer inside between the two pulley wheels may also be necessary. Print 2x: Block 13042018 print 4x: Pulley wheel pulley wheel 13042018 creates an 11mm wide pulley wheel If using pulley wheel 13042018 then there is no need to include the large washer. (not recommended) pulley wheel 20042018 creates a 10mm wide pulley wheel if using pulley wheel 20042018 then a large washer (30mm diameter) is necessary. (recommended) I intend to improve the design at some point in the future by reducing the friction created by the faces of the wheels and possibly adding beari…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Pulley (Block and tackle) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by stewartmiller.
- Who made this model?
- Designed by stewartmiller, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Pulley
