Tape dispenser cutter 50mm - V2.5
Source: Thingiverse by _Stefano17_
The Tape dispenser cutter 50mm - V2.5 is a free printable 3D model from Thingiverse by _Stefano17_. Hello, after several projects, I found a compromise, which is valid for two uses. You can download the STL file from the original listing below and print it at home.
About this model
Hello, after several projects, I found a compromise, which is valid for two uses. It is possible to use the kit with or without cutter, depending on your needs. It is possible to use the two supports at will, only one of the two or both coupled together. The tolerances of the joints are 0.2mm The press was made in ABS, it is a while that I use it and I have not seen signs of failure, if there were any problems I remain available. The project was designed for 50mm thick tape
Frequently asked questions
- Is this 3D model free to download?
- Yes. Tape dispenser cutter 50mm - V2.5 is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by _Stefano17_.
- Who made this model?
- Designed by _Stefano17_, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Tape
