Jewelry Box with dividers
Source: Thingiverse by TheGreatMrBill
The Jewelry Box with dividers is a free printable 3D model from Thingiverse by TheGreatMrBill. I created 2 different removable dividers for the box that separate it into 2 or 4 sections. You can download the STL file from the original listing below and print it at home.
About this model
I created 2 different removable dividers for the box that separate it into 2 or 4 sections. They are the right height to place both dividers inside at the same time when giving it as a gift. I also created a box shaped floor panel that gives enough room on the sides to wrap around Velvet (what I used) or any material and glue it to the back side. I used a thick padding on the floor panel first and then used velvet material to go over (See last pictures above). When the floor panel is done, it will fit tightly in place as you push it evenly toward the floor. I put some hot glue in the bottom before I pushed the velvet floor panel down into place. Though it was so tight that the glue probably wasn't necessary. I also created a placard for the bottom of the lid so you could put a message or s…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Jewelry Box with dividers is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by TheGreatMrBill.
- Who made this model?
- Designed by TheGreatMrBill, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Jewelry
