LASER ENGRAVER ROTARY CHUCK Small double chuck
Source: Thingiverse by Hassan_19940
The LASER ENGRAVER ROTARY CHUCK Small double chuck is a free printable 3D model from Thingiverse by Hassan_19940. It is possible to install one chuck or both together to save some time and drill two parts at the same time. You can download the STL file from the original listing below and print it at home.
About this model
It is possible to install one chuck or both together to save some time and drill two parts at the same time. •3-jaw chuck 50mm is suitable for catching small parts during the laser engravings process, such as rings, wooden pens, and anything with a diameter of 25 mm or less. •The three self-centering jaws are reversible to allow the holding of larger workpieces. jaws installed in order 1, 2, and 3 to match the numbers on the housing. To fit them reversed, insert them in the order 3,2,1. Fit the slider plate into the housing and place the Circlips over the shaft to secure it. Turn the slider over so that the front end of the slider is about to pop into one of the slots. Feed into Jaw 1, large end first, and rotate the slider plate to snap it. Repeat with Jaw 2 in the next hole, then Jaw 3 i…
Frequently asked questions
- Is this 3D model free to download?
- Yes. LASER ENGRAVER ROTARY CHUCK Small double chuck is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Hassan_19940.
- Who made this model?
- Designed by Hassan_19940, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in LASER
