Is this 3D model free to download?

Yes, Garmin CV20-TM Transducer Mount for 1-1/2 inch pipe is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by jabixby, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Garmin CV20-TM Transducer Mount for 1-1/2 inch pipe 3D printable model by jabixby

Garmin CV20-TM Transducer Mount for 1-1/2 inch pipe photo 1

Garmin CV20-TM Transducer Mount for 1-1/2 inch pipe photo 2

Garmin CV20-TM Transducer Mount for 1-1/2 inch pipe photo 3

Garmin CV20-TM Transducer Mount for 1-1/2 inch pipe photo 4

Garmin CV20-TM Transducer Mount for 1-1/2 inch pipe

Source: Thingiverse by jabixby

The Garmin CV20-TM Transducer Mount for 1-1/2 inch pipe is a free printable 3D model from Thingiverse by jabixby. This is a transducer mount to attach a Garmin CV20-TM transducer to 1.5 inch ABS or PVC pipe. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

54 saves Source: Thingiverse Updated 2026-10-15 License: CC-BY · commercial OK Category: Outdoor & Garden

Tags: Garmin, CV20-TM, Transducer, Mount, for, 1-1/2, inch, pipe

About this model

This is a transducer mount to attach a Garmin CV20-TM transducer to 1.5 inch ABS or PVC pipe. I designed this for the rod holders I made from ABS pipe for my float tube. The rod holders were made according to Fish Newb's design (with some modification), published on YouTube: Print this at 0.2mm resolution or better - high resolution is needed to faithfully create the detent rings. I used the part that is attached permanently to the transducer from Garmin, and this mount matches that part - see the photos. Print without supports. There are three small supports built into the design. One of the photos shows these, which are to be cut away after printing. Hardware: all stainless steel, use 10-24 or 10-32 screws/nuts. For the transducer pivot screw, 1-3/4 length, with washer and nyloc nut. For…

Frequently asked questions

Is this 3D model free to download?: Yes. Garmin CV20-TM Transducer Mount for 1-1/2 inch pipe is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by jabixby.
Who made this model?: Designed by jabixby, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.