Is this 3D model free to download?

Yes, Altair 8800 Raspberry Pi 3 case is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by RabbitEngineering, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Altair 8800 Raspberry Pi 3 case 3D printable model by RabbitEngineering

Altair 8800 Raspberry Pi 3 case

Source: Thingiverse by RabbitEngineering

The Altair 8800 Raspberry Pi 3 case is a free printable 3D model from Thingiverse by RabbitEngineering. The Altair 8800 was a super influential computer, and now you can have your own, in the shape of a Raspberry Pi case! You can just print this out and have a basic case, or you. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

104 saves Source: Thingiverse Updated 2026-10-15 License: CC-BY-NC · non-commercial 1 makes Category: Gadgets & Electronics

Tags: Altair, altair 8800, cute, History, Raspberry Pi, raspberry pi case

About this model

The Altair 8800 was a super influential computer, and now you can have your own, in the shape of a Raspberry Pi case! You can just print this out and have a basic case, or you can add LEDs to the GPIO pins to create a more realistic simulation of the old brick. You can see the LED mod in action here: This should fit either the Pi 3 or 4. Too lazy to print your own? Buy one from our store - PARTS NEEDED: 4 x M2.5x18mm screws and M2.5 nuts to go with them 3 x #6 x 1/2 inch screws 4 x 1/4" little rubber feet (due to the screws at the bottom of the case, you need these feet to make the case sit right). Some double-sided tape to stick the face sticker to the face part Super glue or hot glue. Optionally you can add up to 12 5mm LEDs; you will also need a 330 ohm resistor to go with each LED. The…

Frequently asked questions

Is this 3D model free to download?: Yes. Altair 8800 Raspberry Pi 3 case is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by RabbitEngineering.
Who made this model?: Designed by RabbitEngineering, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.