SD card WiFi adapter
Source: Thingiverse by willfly
The SD card WiFi adapter is a free printable 3D model from Thingiverse by willfly. Tired of ejecting the SD card from 3d Printer for adding new gcode - this adapter makes it WiFi enabled, i.e. You can download the STL file from the original listing below and print it at home.
About this model
Tired of ejecting the SD card from 3d Printer for adding new gcode - this adapter makes it WiFi enabled, i.e. you can remotely upload the gcode from your computer to the SD card. This module based on ESP8266 reads/writes to SD card, and also leaves the SD card interface open to reading from 3d printer. It works well with the RAMBO board and Marlin firmware in my printer, but should work in any setup that uses a SD card. A Toshiba Flash Air SD card which is commercially available, will do this as well, in case you want to save the trouble of soldering and programming chips. Details: My printer uses "RepRap full graphic LCD controller" and supports printing from a SD card. I replaced the SD card with this module - which is a blank fullsize SD card adapter, ESP82668266 and a microSD card. See…
Frequently asked questions
- Is this 3D model free to download?
- Yes. SD card WiFi adapter is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by willfly.
- Who made this model?
- Designed by willfly, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
