Caliper hole - hole / hole - edge tips (for resin)
Source: Thingiverse by ornotermes
The Caliper hole - hole / hole - edge tips (for resin) is a free printable 3D model from Thingiverse by ornotermes. Add on for regular calipers to measure center - center distance between holes as well as center to edge. You can download the STL file from the original listing below and print it at home.
About this model
Add on for regular calipers to measure center - center distance between holes as well as center to edge. Intended for resin printers. Minimum measurement about 10.2 mm cc, or 5.1 mm center-edge. My normal setup consist of two conical tip and one flat. You need ------------- - Resin printer setup - Calipers (jaws < 3.3mm wide, all 3 i have fits no problem) - 3x regular M3 nuts - 3x M3 screws, preferable 10-12 mm socket cap with knurling for easy finger tightening Usage --------- If you want to measure against an edge, start by putting on the flat piece on one jaw and zero the caliper out, if you use non-digital you have to measure the offset and subtract it (should be just a hair or two over 5mm) from any measurement. If using two conical tip the calipers should be zeroed as normal, the tip…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Caliper hole - hole / hole - edge tips (for resin) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by ornotermes.
- Who made this model?
- Designed by ornotermes, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Caliper
