Neptune 4 Max leveling knobs
Source: Thingiverse by Deathmask666
The Neptune 4 Max leveling knobs is a free printable 3D model from Thingiverse by Deathmask666. The Neptune 4 MAX uses M4 bolt for the bed support with a thread pitch of 0.8mm. You can download the STL file from the original listing below and print it at home.
About this model
The Neptune 4 MAX uses M4 bolt for the bed support with a thread pitch of 0.8mm. This means that by dividing the circumference of the knob into 8 segments, moving the knob by 1/8 rotation will raise or lower the bed by 0.1mm. Each segment is divided into 5 sub-segments, each moving the bed by 0.02mm. keep in mind this is plastic so before you install them but a hex bit in a drill and spin them back and forth a while tell the knob spins freely on the screw ( i did not have to do it to mine but......) on my brothers we had to put some 5 minute epoxy on the cap side of the screw to lock the screw into place and yes after one of the screws cured we broke it free again without issue just to make sure we could by the way looking at the printer the back LEFT side knob can NOT be replaced with one…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Neptune 4 Max leveling knobs is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Deathmask666.
- Who made this model?
- Designed by Deathmask666, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Neptune
![[BETTER] Elegoo Neptune 4 / 4 Pro / 3 / 3 Pro Tool Holder 3D model](https://cdn.thingiverse.com/assets/fa/e1/1c/72/d0/card_preview_1f7f32a7-f063-4608-bfa3-4c08cc6a3fb2.png)
