Succulent dome
Source: Thingiverse by NT_Toys
The Succulent dome is a free printable 3D model from Thingiverse by NT_Toys. Something to decorate your desk :) Dome: PolySmooth™ Transparent Printer: Mass Portal Pharaoh ED15 (0.6 nozzle) 0.2 layer height 0.75 extrusion width 210˚C / 60˚C Vase mode. You can download the STL file from the original listing below and print it at home.
About this model
Something to decorate your desk :) Dome: PolySmooth™ Transparent Printer: Mass Portal Pharaoh ED15 (0.6 nozzle) 0.2 layer height 0.75 extrusion width 210˚C / 60˚C Vase mode 40mm/s printing speed (with cooling overwriting) (Lower the jerk and acceleration of your printer if its a commun cartesian printer :) ) I poor alcohol inside to the top (like a cup) for 3-5min, I then polished the outside faces with the Polysher for 3*10min (5min drying with a fan). Base: PolyWood™ As for the base I used the same printer, PolyWood™ profile with over extrusion, sand it down slightly with a file then use a lighter to even out everything. The succulent is not from me but I dont find the link anymore so I post the stl i downloaded :( It was smth like this : Hope that help :)
Frequently asked questions
- Is this 3D model free to download?
- Yes. Succulent dome is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by NT_Toys.
- Who made this model?
- Designed by NT_Toys, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Succulent
