Screw Jack for K40 Laser
Source: Thingiverse by atmonaut
The Screw Jack for K40 Laser is a free printable 3D model from Thingiverse by atmonaut. Screw jacks for supporting the bed of K40 laser cutters. You can download the STL file from the original listing below and print it at home.
About this model
Screw jacks for supporting the bed of K40 laser cutters. Materials: 5/16-18 threaded rod (12") Brass 5/16-18 nuts from Home Depot 3mm socket head cap screws ~20mm 1.5" round metal disk to prevent the laser from damaging the 3d printed components. To build, cut 5/16-18 threaded rod to the length of the top and bottom parts at minimum height. Then dremel a slot into one end for a flat head screw driver. Install the brass nuts into the base component, this should be press fit and may need to be hammered in. Screw the threaded rod into the base, leave an inch and a half or so out of the top. Use a screwdriver from the back to keep the rod from spinning and heat up the end with a lighter, screw the top component onto the threaded rod. Using a drill, drill and tap the threaded rod, install in th…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Screw Jack for K40 Laser is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by atmonaut.
- Who made this model?
- Designed by atmonaut, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Screw
