Finger Skateboard (One-Wheeled)
Source: Thingiverse by V0XeL
The Finger Skateboard (One-Wheeled) is a free printable 3D model from Thingiverse by V0XeL. You need to print out at least: - Two rails of your choice - Two bumpers - Two footpads - One tyre If you're unsure what to print, start out with these STLs for the "plain". You can download the STL file from the original listing below and print it at home.
About this model
You need to print out at least: - Two rails of your choice - Two bumpers - Two footpads - One tyre If you're unsure what to print, start out with these STLs for the "plain" board, shown in the third picture: - grip_tape.stl (2x, cut off a bit from the back one after printing to match the picture) - rail_left_and_right.stl (2x) - footpad.stl (2x) - bumper.stl (2x) - tyre_slick.stl (1x, soft filament) You also need - Two 608 bearings - pull them out of an old fidget spinner (outer diameter: 22mm, inner diameter: 8mm, thickness: 7mm - or use the OpenSCAD file to set it to fit whatever bearings you have lying around) - Four M2 screws (at least 8mm, at most 12mm) Fenders are specifically designed to work with the regular, straight rails, and may not work with other rails. Please refer to the .3…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Finger Skateboard (One-Wheeled) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by V0XeL.
- Who made this model?
- Designed by V0XeL, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Finger
