Dice Mold D10
Source: Thingiverse by bloodbunny_92
The Dice Mold D10 is a free printable 3D model from Thingiverse by bloodbunny_92. The 2 pieces fit together to create a tube that is taped together, make sure the labels are at the bottom and upside down. You can download the STL file from the original listing below and print it at home.
About this model
The 2 pieces fit together to create a tube that is taped together, make sure the labels are at the bottom and upside down. Lay down 2 pieces of tape overlaping and place die face firmly on it. Put the tube over the die centering it as much as possible, then pull the tape up along the sides of the tube to seal as much as possible. After, you can mix and pour the silicone and put it straight into the pressure pot to get rid of any bubbles. After taking it out and removing it from the tube, cut out your keys and vasaline the top part of the mold including keyholes. Now were doing to lid so instead of where the label is your going to put the mold back in the tube at the opposite end. after putting the mold back in and retaping, your going to mix and pour your silicone again and put the top wit…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Dice Mold D10 is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by bloodbunny_92.
- Who made this model?
- Designed by bloodbunny_92, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Dice
