Pi 3 Version: Ender 3 S1 Case for RPi and 2x XL4005 buck converter
Source: Thingiverse by koswix
The Pi 3 Version: Ender 3 S1 Case for RPi and 2x XL4005 buck converter is a free printable 3D model from Thingiverse by koswix. This is a remix of nelik's Ender 3 S1 Raspberry Pi Case to fit the Raspberry Pi 3 port layout. You can download the STL file from the original listing below and print it at home.
About this model
This is a remix of nelik's Ender 3 S1 Raspberry Pi Case to fit the Raspberry Pi 3 port layout. This upload only contains the case bottom part, you will need to download nelik's original file to get the lid and the base that attaches to the printer. Replace the Case.stl in that download with the Case-Pi3.stl from this one. Original ---> There is space for two XL4005 voltage converts in the case, you can use one to power the pi and one for something else (LEDs light or similar), taking power off from the S1's expansion interface on the back right. You'll need a 3 pin JST-XH cable to plug into the expansion interface (loads of options on ebay etc) Also contains a 19.10 x 12.70mm (3/4 x 1/2 in) cut out for an on off rocker switch.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Pi 3 Version: Ender 3 S1 Case for RPi and 2x XL4005 buck converter is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by koswix.
- Who made this model?
- Designed by koswix, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
