Airtag Twist and Lock Case Keyring
Source: Thingiverse by Elppa8
The Airtag Twist and Lock Case Keyring is a free printable 3D model from Thingiverse by Elppa8. AirTag holder case that twists from any direction to contain the AirTag and locks in place when fully closed via a small block and hole. You can download the STL file from the original listing below and print it at home.
About this model
AirTag holder case that twists from any direction to contain the AirTag and locks in place when fully closed via a small block and hole. To release pull slightly apart at the top and twist. I found printing as shown in the STL got the best results for the mating surface. I used 0.4 nozzle and 0.2 layer height but 0.16 or 0.12 should work ok. Support to build plate seems to work ok. I have made up a thinner version. It is a bit easier to print as there is no support required for the base on the face side.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Airtag Twist and Lock Case Keyring is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Elppa8.
- Who made this model?
- Designed by Elppa8, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
