Snapmaker 2.0 Internal Spool Holder with Weight Sensing
Source: Thingiverse by JohnAHind
The Snapmaker 2.0 Internal Spool Holder with Weight Sensing is a free printable 3D model from Thingiverse by JohnAHind. This spool holder is intended for mounting spools inside the enclosure of a Snapmaker 2.0 printer. You can download the STL file from the original listing below and print it at home.
About this model
This spool holder is intended for mounting spools inside the enclosure of a Snapmaker 2.0 printer. The holder is assembled from the attached prints and the following additional components: 1. 2020 Aluminium Extrusion, 150mm and 100mm. 2. 2020 Right Angle Jointing Brace. 3. 2020 T-Shape Outside Jointing Plate 4. Slide Nuts for 2020 and Bolts. 5. 4x 12x4mm Plastic Ball Bearings 6. Optional 5kg Strain Gauge Load Cell (4-wire) 7. Optional RJ11 Breakout Board (PiHut/BCRobotics) Two Spool_Holder prints are prepared by screwing two bearings to each with M4 screws self-tapped into the plastic. The two assemblies are then slid onto the shorter, horizontal 2020 beam oriented with the bearings on the outside. If load sensing is not required, the shorter beam may be attached at right angles to the lon…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Snapmaker 2.0 Internal Spool Holder with Weight Sensing is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by JohnAHind.
- Who made this model?
- Designed by JohnAHind, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Snapmaker
