Sunlu Dryer Box Filament Guide 6mm Bowden
Source: Thingiverse by jerryfudd
The Sunlu Dryer Box Filament Guide 6mm Bowden is a free printable 3D model from Thingiverse by jerryfudd. Remix: - Purpose: - Liked DiJo's design and have it printed and fitted on both of my Sunlu FilaDryer's but after moving the filament kept getting caught up round bends in the 4mm. You can download the STL file from the original listing below and print it at home.
About this model
Remix: - Purpose: - Liked DiJo's design and have it printed and fitted on both of my Sunlu FilaDryer's but after moving the filament kept getting caught up round bends in the 4mm OD bowden. I have remixed for a 6mm OD bowden tube. Note: - Now printed, as the pic shows so no longer a 'work in progress' - Uses exactly the same footprint as DiJo's original design so is a direct swap out, note that after fitting you will need to put a 6mm drill bit through the bowden route from out side to in. - I'm still using this with 1.75mm filament, so your experience with 2.85mm may vary - Tube used here - Bowden fittings here - I found it easier to push the tube through the fitting then fit to the box (after a test fit of the coupling) - Lastly, I'd always recommend getting a 1/8 BSP tap to clean the th…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Sunlu Dryer Box Filament Guide 6mm Bowden is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by jerryfudd.
- Who made this model?
- Designed by jerryfudd, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
