Razor Guillotine
Source: Thingiverse by Botmaster
The Razor Guillotine is a free printable 3D model from Thingiverse by Botmaster. I needed a way of cutting heat shrink tube into repeatable short lengths. You can download the STL file from the original listing below and print it at home.
About this model
I needed a way of cutting heat shrink tube into repeatable short lengths. It also needed to be safe and not have any exposed blades. the hole is 6mm sq, the largest I could make it without somebody getting their finger in it. It is all 3D printable, The only extras are the guide rods these are K&S stock #508 5/32 music wire that can be purchased at any model shop. A single edge razor blade and 2 light weight springs. WARNING Be very careful inserting the razor blade into the holder. As I have no control over your usage you accept full responsibility for building and using this tool. I had a request for a 50 mm cut capacity, I have added the STL for this. I have not printed it but it should be fine, please let me know if you have any issues with this. Updated 50mm base file due to rod hole …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Razor Guillotine is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Botmaster.
- Who made this model?
- Designed by Botmaster, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Razor
