Ender 3 V2 Raspberry Pi Case
Source: Thingiverse by monokeith
The Ender 3 V2 Raspberry Pi Case is a free printable 3D model from Thingiverse by monokeith. Printed with White PETG because this is the only white filament I have. You can download the STL file from the original listing below and print it at home.
About this model
Printed with White PETG because this is the only white filament I have. It will look better if printed with PLA. I didn't put a fan in the design because I have modded the original 40mm controller fan with a 80mm fan, it pushes a lot of air through the vents, should also be able to cool down the Pi. Fan Mods I used: Camera Case I used: I soldered the USB2.0 D+ and D- directly on the controller board, as well as on my RaspberryPi 4. And connected a power wire from the PSU to a LM2596 to get 5V to power the Pi directly from its GPIO pins. So I don't need to run any cable (except for the camera) outside the case. The top cover is separated, so future mods can be done easily. I am planning to make another LCD screen into the top cover, for OctoPrint. I have included the f3d design files so you…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Ender 3 V2 Raspberry Pi Case is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by monokeith.
- Who made this model?
- Designed by monokeith, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Ender
