Unifi UAP-IW-HD wall mount spacer for In-Wall HD accesspoint
Source: Thingiverse by Demis
The Unifi UAP-IW-HD wall mount spacer for In-Wall HD accesspoint is a free printable 3D model from Thingiverse by Demis. This wall-mount is a spacer for mounting the Ubiquiti Unifi In-Wall HD access point on a wall or ceiling, effectively making it an On-Wall HD :) This probably works for the other. You can download the STL file from the original listing below and print it at home.
About this model
This wall-mount is a spacer for mounting the Ubiquiti Unifi In-Wall HD access point on a wall or ceiling, effectively making it an On-Wall HD :) This probably works for the other In-Wall series from Unifi but I haven't tested them. Credits to Aviate for the inspiration from his design. The supports are needed for the screw mounts for the access point. The holes need to be drilled in depending on the type of screws you use. When mounting the access point I discovered that the screw mounting blocks for the access point plate are of course hollow with some infill. If you use a higher infill, the screws should work better. Otherwise you can mount it with an M4/M3 bolt and nut. Added note: Use a self-made cable cable, otherwise the case is not high enough. Made with Tinkercad. Good luck with pr…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Unifi UAP-IW-HD wall mount spacer for In-Wall HD accesspoint is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Demis.
- Who made this model?
- Designed by Demis, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
