Subaru Intake Component Body Clip
Source: Thingiverse by natethegreat_501
The Subaru Intake Component Body Clip is a free printable 3D model from Thingiverse by natethegreat_501. Intake component clips are used all over the intake system on many models of Subarus. You can download the STL file from the original listing below and print it at home.
About this model
Intake component clips are used all over the intake system on many models of Subarus. These clips break easily and are fairly expensive to replace a single unit or buy a whole pack (considering after all... it is just plastic)... not anymore. The diameter of the clip is factory spec and fits a 7mm hole. The thread-type clip will open at the bottom when screwed in using a flathead to secure it in place... an identical mechanism to the factory clip. The top of the clip is 20mm and the factory clip is 19.9mm (not a noticeable difference in diameter), the shank is 13.2mm deep (factory size), the diameter of the shank is 6.8mm (factory size), and the threaded screw top measures in at 13mm in diameter (also factory size). Clip prints in two parts, outer and inner pieces print next to each other …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Subaru Intake Component Body Clip is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by natethegreat_501.
- Who made this model?
- Designed by natethegreat_501, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Subaru
