Tiny Hawk II Freestyle Battery hold down
Source: Thingiverse by adamegg
The Tiny Hawk II Freestyle Battery hold down is a free printable 3D model from Thingiverse by adamegg. This is a battery hold down for the Tattu 450 Mah battery. You can download the STL file from the original listing below and print it at home.
About this model
This is a battery hold down for the Tattu 450 Mah battery. Front part has a clip for the VTX antenna to keep it out off the way. The rear part is just a clip, maybe print a couple just in case, wrecks and all or just use velcro for the rear but the front nose is handy. The inside of the nose is 16.5mm tall and 13mm wide. I printed the nose face down with supports for the wire clip. When put into my slicer need to scale up to 1000% so double check your scale before printing. 6-29 Added a longer front nose piece. Antenna holder is further back. And can possibly use without any other strap on the rear if you use one of my XT30 holders. Printed the same as other nose face down with supports.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Tiny Hawk II Freestyle Battery hold down is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by adamegg.
- Who made this model?
- Designed by adamegg, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Tiny
