Anet A6 (and A8) Glass Bed Corner Holders
Source: Thingiverse by Xerses
The Anet A6 (and A8) Glass Bed Corner Holders is a free printable 3D model from Thingiverse by Xerses. I liked the original heavy duty design made by thfo ( but it needed to be tweaked for the Anet A6. You can download the STL file from the original listing below and print it at home.
About this model
I liked the original heavy duty design made by thfo ( but it needed to be tweaked for the Anet A6. FYI I use 3mm glass on my hotbed. Below are the changes and improvements made: - Moved the screw hole to center it for the A6 hotbed and allow it to be tight on the edges of the bed. - Increased the screw hole size to allow the M3 screw to slide through. - Added a circular slot around the screw hole to keep the bed spring centered. (Best when used with spring washers on the bottom as well: I printed it in PLA since my bed never goes over 60C, but you should use a more heat resistant filament if you print in ABS, or other high heat filament. Do NOT use the full holder on the home corner, the pre-extrusion happens directly on the holder. Use the home corner holder for the home corner. If you ha…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Anet A6 (and A8) Glass Bed Corner Holders is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Xerses.
- Who made this model?
- Designed by Xerses, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Anet
