Autobots Matrix of Leadership
Source: MyMiniFactory by Adam McDonnough
The Autobots Matrix of Leadership is a free printable 3D model from MyMiniFactory by Adam McDonnough. Printed in PLA I purchased some Solmore RGB Cabinet Lights (Model NO.:S-CL-003) and remixed the insides of the original matrix ( to fit. You can download the STL file from the original listing below and print it at home.
About this model
Printed in PLA I purchased some Solmore RGB Cabinet Lights (Model NO.:S-CL-003) and remixed the insides of the original matrix ( to fit. Tolerances are tight so glue may not be needed. NOTE: You must have an IR remote (included in light pack) for this build to work. Disassemble the Solmore light and retain the screws holding the front cover to the battery pack. 1) Gently press the LED and battery pack into the Crystal. This is a tight fit. The ridge on the battery pack will prevent the LED from going in too far. 2) Press the Crystal into the Front Ball. 3) Press the Back Ball onto the Front Ball, align so that the flat sides allow for a tight seal. 4) Insert the Arms into the grooves formed on top and bottom of the the constructed ball. Glue may be necessary to hold these in place. 5) Inse…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Autobots Matrix of Leadership is free to download from MyMiniFactory. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MyMiniFactory, not by Thinger. We link you directly to the original listing by Adam McDonnough.
- Who made this model?
- Designed by Adam McDonnough, published on MyMiniFactory. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in transformers
