Is this 3D model free to download?

Yes, Corner for Cards and Pictures is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by peaberry, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Corner for Cards and Pictures 3D printable model by peaberry

Corner for Cards and Pictures

Source: Thingiverse by peaberry

The Corner for Cards and Pictures is a free printable 3D model from Thingiverse by peaberry. Simple corner for holding credit cards, business cards, pictures or photos on any flat surface. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

31 saves Source: Thingiverse Updated 2026-10-23 License: CC-BY · commercial OK Category: Home & Organization

Tags: card, card holder, corner, corners, creditcard, credit card, credit card holder, holder, photo, picture, picture holder

About this model

Simple corner for holding credit cards, business cards, pictures or photos on any flat surface. Just add some self adhesive tape, foam tape or magnetic tape to the back. Prints without support. Print two of them and you have a handy place to store a card (e.g. with your wifi router details). Print four to permanently mount a picture. You could probably use Blu Tack for a less permanent fix. The overall size is 20x20mm and the card slot is 1.5mm wide, which should suit most credit cards (I measured ten, which ranged from 0.7mm to 1.26mm thick). Enjoy!

Frequently asked questions

Is this 3D model free to download?: Yes. Corner for Cards and Pictures is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by peaberry.
Who made this model?: Designed by peaberry, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.