HP RTX 3080 Noctua NF-A12x25 Shroud
Source: Thingiverse by hirez
The HP RTX 3080 Noctua NF-A12x25 Shroud is a free printable 3D model from Thingiverse by hirez. This is a drop-in replacement for the very noisy three-fan cooling shroud used in HP OEM RTX 3080 graphics cards. You can download the STL file from the original listing below and print it at home.
About this model
This is a drop-in replacement for the very noisy three-fan cooling shroud used in HP OEM RTX 3080 graphics cards. I designed this shroud for the 120mm Noctua NF-A12x25 PWM fan, but any 120mm case fan should fit. However, NF-A12x25 is recommended because of its high dynamic pressure and low noise. Regular case fans may lack the power to push enough air through the cooling fins. No alterations to the graphics card are needed, this shroud attaches with the same 5 screws as the original. HP RTX 3080 has two JST-PH 4-pin male connectors. Regular fan connectors won't fit without an adapter. It is possible to use motherboard's case fan headers, but for the best experience get two 4-pin PWM fan male to JST-PH 4-pin female adapters, and attach the Noctua fans directly to the GPU. These adapters are…
Frequently asked questions
- Is this 3D model free to download?
- Yes. HP RTX 3080 Noctua NF-A12x25 Shroud is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by hirez.
- Who made this model?
- Designed by hirez, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in HP
