Universal Tweeter Pod
Source: Thingiverse by LV-426
The Universal Tweeter Pod is a free printable 3D model from Thingiverse by LV-426. This is the Universal Tweeter Pod. You can download the STL file from the original listing below and print it at home.
About this model
This is the Universal Tweeter Pod. This was designed so it could be mounted either on the dash board of a vehicle or mounted on the A pillar. You can mount with a 3mm screw so it can be rotated for optimum tweeter positioning or simply use 3M tape to attach it. there is a slot in the back of the foot so speaker cable may be passed through the base of the foot or it can be passed directly through the sole of the foot depending on how you wish to mount it. There is enough room in the rear of the pod so you can leave some slack in the speaker cable to make wiring the tweeter easier, once wired the tweeter can be simply pushed into the pod without too much bunching of the cable. This mounts perfectly on the existing dash speaker grill in an Audi A4 B8K giving you the ability to create a very h…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Universal Tweeter Pod is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by LV-426.
- Who made this model?
- Designed by LV-426, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in audio
