Growth chart router template
Source: Thingiverse by jmccann92
The Growth chart router template is a free printable 3D model from Thingiverse by jmccann92. Router template to be used to make a ruler style growth chart. You can download the STL file from the original listing below and print it at home.
About this model
Router template to be used to make a ruler style growth chart. I used PLA at 15% infill which should hold up for a couple uses. If you use clamps to hold the template down, then you will need to reposition the clamps in order to be able to reach all of the inch marks. I didn't try to use double sided tape, but I'm sure that it would be easier than having to move around clamps. The template allows you to add the numbers above or below the foot line. Note: The top half will always be above the bottom half when moving the template along the board. The inch marks are 1/2" wide. I used a 1/4" bit with a 5/16" bushing.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Growth chart router template is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by jmccann92.
- Who made this model?
- Designed by jmccann92, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
