Wolf Head Keychain (Pencil Topper)
Source: Thingiverse by Littlefiver
The Wolf Head Keychain (Pencil Topper) is a free printable 3D model from Thingiverse by Littlefiver. In addition to remixing a full sized Wolf Head for my son's Cub group, I made this smaller version. You can download the STL file from the original listing below and print it at home.
About this model
In addition to remixing a full sized Wolf Head for my son's Cub group, I made this smaller version. It is designed to be printed in one piece, angled facing up 45 degrees, so the chin prints properly. (The STL should load into Cura already at the proper angle). This print requires supports everywhere. I used tree supports. I also recommend a brim. There is a key Ring loop at the back and a hole to be used as a pencil topper. Note: I tried a few pencils and some seem to be slightly bigger or smaller than others. I designed it to fit the pencils I had bought for this.There will also be variations depending on your printer setup. You can compensate for minor variations with Cura's "Horizontal Expansion". If the hole is too big or to loose, try increasing your Horizontal Expansion (ex 0.05 mm)…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Wolf Head Keychain (Pencil Topper) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Littlefiver.
- Who made this model?
- Designed by Littlefiver, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Wolf
