Flashlight Scope Clamp / Mount
Source: Thingiverse by mighty_mace
The Flashlight Scope Clamp / Mount is a free printable 3D model from Thingiverse by mighty_mace. Drew up a little flashlight clamp to mount my red flashlight to scope for hunting coyotes. You can download the STL file from the original listing below and print it at home.
About this model
Drew up a little flashlight clamp to mount my red flashlight to scope for hunting coyotes. Both diameters of the clamp are set up for a 1" tube. A 1/4 x 20 bolt is used to join the pieces and I added a cap to the bolt to allow adjustment without tools. The one side is recessed to house the 1/4 x 20 nut. I may build up the bolt side so a spacer is not needed with the cap but this works for now. I printed with supports but you probably don't need them (makerware only added support in the center of the through holes. The scope clears my 40mm objective but I haven't tried it on the 50mm. I may have to make the entire assembly longer if it is an issue.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Flashlight Scope Clamp / Mount is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by mighty_mace.
- Who made this model?
- Designed by mighty_mace, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in coyotes
