Fostruder H4 - Dual Drive Extruder
Source: Thingiverse by walter
The Fostruder H4 - Dual Drive Extruder is a free printable 3D model from Thingiverse by walter. Dual motor, dual drive bowden extruder. You can download the STL file from the original listing below and print it at home.
About this model
Dual motor, dual drive bowden extruder. Uses two NEMA14 motors and two drive gears. The two motors should be wired to run in opposite directions, and can be wired in serial or parallel (I would tend to wire the motors in series on a 24V printer and parallel on the 12V printer, but it will also depend on the motors and drivers). Two screws are used to adjust the gap between the gears, or small springs* can be used for a constant tension configuration. Here are the parts I used: * 2 x 0.8A NEMA14 Motors 2 x Stainless steel extruder gears * 1 x Bowden Coupler * M3 Screws (two M3x20, four M4x30 socket cap screws) More info about several other dual drive bowden extruders I've just uploaded on thrinter.com Printed in Atomic Filament Ruby Red PETG* **affiliate link*
Frequently asked questions
- Is this 3D model free to download?
- Yes. Fostruder H4 - Dual Drive Extruder is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by walter.
- Who made this model?
- Designed by walter, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in 2wd
