Housing for 1 channel 5V relay to be installed inline on power cord.
Source: Thingiverse by jasondelane
The Housing for 1 channel 5V relay to be installed inline on power cord. is a free printable 3D model from Thingiverse by jasondelane. This is a box made for 50mm x 26mm 1 channel optocoupler relays. You can download the STL file from the original listing below and print it at home.
About this model
This is a box made for 50mm x 26mm 1 channel optocoupler relays. It has guide pins to keep the board from moving inside the box, and slots cut into the ends so that it can be installed inline on a 120/240 power cord. You can then use a Raspberry PI to switch the power on and off using 3 wires with female connector on one end for the PI and male connector for the relay. There is plenty of room in the box to accommodate cables. Holes or strain relief may be added in a future update to this housing. Also included is a lid that will accommodate a taller relay board if the wires aren't trimmed well or if you want to put some type of cushion between the board and the relay. An example of the relay this is built for is I am using this in conjunction with Octopi PSU plugin to remotely switch power…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Housing for 1 channel 5V relay to be installed inline on power cord. is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by jasondelane.
- Who made this model?
- Designed by jasondelane, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Housing
