Is this 3D model free to download?

Yes, Microphone Arm - Swing - Wall-Mounted Low-Profile Height-Adjustable is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by spaxcell, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Microphone Arm - Swing - Wall-Mounted Low-Profile Height-Adjustable

Source: Thingiverse by spaxcell

The Microphone Arm - Swing - Wall-Mounted Low-Profile Height-Adjustable is a free printable 3D model from Thingiverse by spaxcell. I designed this Microphone swing arm to suit my specific purpose as I couldn't find anything else that worked exactly as I wanted it to. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-10-08 License: CC0 · commercial OK Category: Office

Tags: low profile, Microphone, microphone holder, Microphone mount, Microphone stand, swing arm, wall mount

About this model

I designed this Microphone swing arm to suit my specific purpose as I couldn't find anything else that worked exactly as I wanted it to. The only things besides the 3d prints used are the screws and a pole 25.4mm outer diameter. This is the one I used from Bunnings. - I wanted the microphone mounted to the wall so bumps on the desk would not travel to the mic. - I wanted it height adjustable since I have a sit/stand desk. - I wanted it low profile so it would sit below my line of sight from whatever monitor setup I have. - I wanted it to articulate around whatever gaming peripherals I was using (HOSAS/Sim Wheel) The following should be printed with support. - the mic arm parts - the mic rods (these are printed lying down to make them stronger) - the lower pole support I use a setting on my…

Frequently asked questions

Is this 3D model free to download?: Yes. Microphone Arm - Swing - Wall-Mounted Low-Profile Height-Adjustable is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by spaxcell.
Who made this model?: Designed by spaxcell, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.