Ant Trap
Source: Thingiverse by Sardi
The Ant Trap is a free printable 3D model from Thingiverse by Sardi. I found that you always got a lot of the Ant bait/poison fluid when you bought the rather expensive ant-traps. You can download the STL file from the original listing below and print it at home.
About this model
I found that you always got a lot of the Ant bait/poison fluid when you bought the rather expensive ant-traps. Also, they were sometimes not really re-usable (very flimsy). I therefore designed these widgets which have a small dimple to take a few drops of the bait. The lid just pushes on (you may need to sand a little to make sure they come off again) and prevents rain washing the bait away or larger animals getting to it. I print in ABS but PLA should be fine too (though I would put a dab of varnish on the inner surface in that case if you plan to use them inside the house as PLA can allow fluid to seep through. I believe you can use a Borax/Sugar solution if you don't have access to the bait fluid. Thanks, Enjoy!
Frequently asked questions
- Is this 3D model free to download?
- Yes. Ant Trap is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Sardi.
- Who made this model?
- Designed by Sardi, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Ant
