Water butt bung
Source: Thingiverse by windchine
The Water butt bung is a free printable 3D model from Thingiverse by windchine. Water butt bung to plug up an old 1 inch / 25mm pipe connector hole (I couldn't find one to buy so made this one). You can download the STL file from the original listing below and print it at home.
About this model
Water butt bung to plug up an old 1 inch / 25mm pipe connector hole (I couldn't find one to buy so made this one). Requires 2 soft rubber washers and may benefit from a light smear of sealant on the washer surfaces and threads. Threads may require a little a little light clean up after printing, but some roughness is good as it helps the thread lock in place once secured. Secured using an Allen key and spanner from inside the tank. Uses 3rd party libraries for the threads and Allen key socket hexagon: Fully parametric design in OpenSCAD so easy to customise.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Water butt bung is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by windchine.
- Who made this model?
- Designed by windchine, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Water
