Drawer for spool FDPlast
Source: Thingiverse by Sklif
The Drawer for spool FDPlast is a free printable 3D model from Thingiverse by Sklif. PETG Hotend 240 Bed 85 Layer 0.3 Slicer Repetier Host Slic3r Speed 40-45 Time for printing 8 pcs (for one spool) - near 14 h. You can download the STL file from the original listing below and print it at home.
About this model
PETG Hotend 240 Bed 85 Layer 0.3 Slicer Repetier Host Slic3r Speed 40-45 Time for printing 8 pcs (for one spool) - near 14 h. The spool is tapered, so the top and bottom are different. Recesses for neodymium magnets 6х2 (as drug) are made in the boxes (they need to be glued), on the contrary, screws are screwed into the spool. This is necessary so that the boxes do not open at the same time when only one is needed. The connection is made with a piece of copper cable with a diameter of 2.5 mm, which is bent from above and below after installation. The spool must be pre-drilled. For multi-storey system you should print Bottom part (1pcs) and Top part (2 psc for each next). During the printing, you must stop printing before 22-23 layer (insert M0 in G-code after 21-22 layer) ane put the femal…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Drawer for spool FDPlast is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Sklif.
- Who made this model?
- Designed by Sklif, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Drawer
