Hand Cranked Vinyl Player
Source: Thingiverse by Oana
The Hand Cranked Vinyl Player is a free printable 3D model from Thingiverse by Oana. When I saw the Ghostly Vinyl contest, I immediately wanted to make a working record player. You can download the STL file from the original listing below and print it at home.
About this model
When I saw the Ghostly Vinyl contest, I immediately wanted to make a working record player. This is a printable hand-cranked record player for vinyl discs. All pieces for this record player are neatly aligned and designed to fit in a 15x15x15cm cube, and print beautifully on the Replicator 2, without any rafting or supports. Once all the pieces are printed, It assembles in about 5 minutes. Then you just add a little glue to make sure nothing flies of as it spins and you're ready to go. You will only need to add a piece of paper, some sticky tape and a needle for the amplifier, and a little bit of glue. For the deluxe edition, you can also get some tiny felt squares and glue them down to the square top, which will reduce friction noise and scratching (though the turntable is lifted off the …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Hand Cranked Vinyl Player is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Oana.
- Who made this model?
- Designed by Oana, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Hand
