Network Cable Comb
Source: Thingiverse by LordNova2
The Network Cable Comb is a free printable 3D model from Thingiverse by LordNova2. Based off of tjmck's "Network Cable Organizer". You can download the STL file from the original listing below and print it at home.
About this model
Based off of tjmck's "Network Cable Organizer". For my home network cabling I needed a comb that supported larger bundles than tjmck's existing design. I went ridiculously larger than my needs were, but this comb can effectively make bundles of 96 cables. Designed for network cables from 5mm to 7mm diameter. Most Cat-7 and quad-shielded RG-6 will still fit through the holes (7.5mm), but will not easily load from the sides.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Network Cable Comb is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by LordNova2.
- Who made this model?
- Designed by LordNova2, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Network
