Shelf Support Pegs (4 & 5mm pins)
Source: Thingiverse by alterob
The Shelf Support Pegs (4 & 5mm pins) is a free printable 3D model from Thingiverse by alterob. Quick printing replacement part, even in PLA they can take a good bit of weight. You can download the STL file from the original listing below and print it at home.
About this model
Quick printing replacement part, even in PLA they can take a good bit of weight. These would be a bit stronger printed in 0.3 instead of 0.2 and with more infill, but if weight is that critical, your probably better off ordering metal parts. The original version was a 5mm pin, but if that is too tight, you can either run a die over the pin to shave it down or switch to the 4mm pin file. These were designed to print without supports.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Shelf Support Pegs (4 & 5mm pins) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by alterob.
- Who made this model?
- Designed by alterob, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
