1U Quarter-rack Shelf
Source: Thingiverse by cmclernon
The 1U Quarter-rack Shelf is a free printable 3D model from Thingiverse by cmclernon. This is a remix of the "1U Half-rack Shelf (1 Post)" by rqdsvw ( . You can download the STL file from the original listing below and print it at home.
About this model
This is a remix of the "1U Half-rack Shelf (1 Post)" by rqdsvw ( . I used MeshMixer to cut the model in half, then exported to STL. I found I couldn't fit the half rack on my print bed and decided I only needed a quarter width for my raspberry pi and relay setup. You could throw a cable tie through the vent holes to secure anything in place. One thing to note is that the plastic wings are thicker than a traditional metal rack mount appliance so you will need screws that are on the longer side to thread into your rack nuts. Works well at 25% infill for the weight I was putting on it.
Frequently asked questions
- Is this 3D model free to download?
- Yes. 1U Quarter-rack Shelf is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by cmclernon.
- Who made this model?
- Designed by cmclernon, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in 1U
